h. Heat sink (see Heat sink on page 76)
i. Modem module (see
Modem module on page 92)
j. System board (see
System board on page 97)
Remove the RJ-11 connector cable:
1. Position the computer right-side up, with the front toward you.
2. Remove the RJ-11 connector (1) from the clip built into the base enclosure.
3. Remove the RJ-11 connector cable from the clips and routing channel (2) built into the base
enclosure.
4. Remove the RJ-11 connector cable from the base enclosure.
Reverse this procedure to install the RJ-11 connector cable.
100 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
