System board
Description
System board for use in models without Windows 8 (includes thermal material)
System board for use in models with Windows 8 Standard (includes thermal material)
System board for use in models with Windows 8 Professional (includes thermal material)
System board for use in models with NetClone (includes thermal material)
1. Prepare the computer for disassembly (Preparation for disassembly on page 22).
2. Remove the access panel (
Access panel on page 23).
3. When replacing the system board, make sure the following components are removed from the
defective system board and installed on the replacement system board:
●
Memory modules (
Memory on page 28)
●
Expansion cards (
Expansion card on page 31)
●
Fan sink (
Fan sink on page 63)
●
Processor (
Processor on page 64)
4. Remove the fan duct from the chassis (
Fan duct on page 52).
5. Rotate the drive cage to its upright position.
6. Disconnect all data and power cables from the system board.
7. Remove the eight Torx screws (1) that secure the system board to the chassis.
66 Chapter 5 Removal and replacement procedures: Small Form Factor
To Next Page
Loading...
