IMPORTANT: Be sure that the touch and WLAN cables are connected between the top of the display
panel and the top of the computer head unit.
2. Hold the display panel 2.5 cm (one inch) above the computer head unit with the display panel shifted
forward 7.5 cm (three inches) (1). Connect the display cable to the display connector on the system
board (2), and then press down the edges of the tape so that it adheres to the system board.
3. Slide the top of the display panel onto the computer head unit (1) so that the top of the display panel is
secured to the top of the computer head unit, and then rotate the display panel down and snap it onto
the computer head unit (2), making sure that all connection points around the display panel are rmly
attached to the computer head unit.
4. Tighten the three captive screws in the slot on the bottom of the computer head unit.
5. Attach the computer head unit to the stand. See Attaching the Engage One head unit to the stand
on page 25
6. Reconnect the power cord and press the power button.
Replacing the display panel 33
To Next Page
Loading...
