7. Install the two screws that attach the CFD to the computer head unit (1), and then connect the CFD cable
to the connector on the system board (2).
IMPORTANT: Make sure the entire CFD cable is pulled all the way through the head unit routing
channel before installing the CFD so that the cable does not get pinched between the CFD and the head
unit.
8. Replace the computer head unit’s display panel. See Replacing the display panel on page 32.
9. Attach the computer head unit to the stand. See Attaching the Engage One head unit to the stand
on page 25.
10. Reconnect the power cord and press the power button.
36 Chapter 3 Hardware congurations and upgrades
To Next Page
Loading...
