7. To install a memory module, slide the new memory module into the socket at approximately a 30° angle
(1), and then press the memory module down into the socket (2) so that the latches lock it in place.
NOTE: A memory module can be installed in only one way. Match the notch on the module with the tab
on the memory socket.
8. Replace the shield over the memory modules by pressing the left side of the shield down onto the
system board (1) and then the pressing the right side down (2).
9. Replace the computer head unit’s display panel. See Replacing the display panel on page 32.
10. Attach the computer head unit to the stand. See Attaching the Engage One head unit to the stand
on page 25
11. Reconnect the power cord and press the power button.
The computer automatically recognizes the additional memory when you turn on the computer.
Installing memory 39
To Next Page
Loading...
