Authorization to access services
If you choose to require authorization to access services, you have to authorize each connection. Your
HP iPAQ always asks you if the connection should be permitted.
1.
Tap the
(iPAQ Wireless) icon.
2.
Tap the Bluetooth tab, and then tap the
(Bluetooth) icon to turn Bluetooth on.
3. Tap Bluetooth > Bluetooth Settings > Services.
4. Tap the service you want to enable: File Transfer, Information Exchange, Serial Port, Personal
Network Server, PIM Synchronization, or Audio Gateway.
5. Select Authorization required.
6. Tap ok.
Use a passkey or bond
To establish a secure connection with another device, you can use the passkey feature or an established
bond. You can also add data encryption to this type of security. A passkey is a code you enter to
authenticate connections requested by other devices. The passkey must be known and used by both
parties or the connection will not be allowed.
1.
Tap the
(iPAQ Wireless) icon.
2.
Tap the Bluetooth tab, and then tap the
(Bluetooth) icon to turn Bluetooth on.
3. Tap Bluetooth > Bluetooth Settings > Services.
4. Tap the service you want to enable: File Transfer, Information Exchange, Serial Port, Personal
Network Server, PIM Synchronization, or Audio Gateway.
5. Select Authorization required and Authentication (Passkey) required if you want more security.
6. Select Encryption Required if you want all the data exchanged between the devices to be
encrypted.
7. Tap ok.
Set a Bluetooth shared folder
You can determine the folder that other devices access when they connect to your HP iPAQ.
1.
Tap the
(iPAQ Wireless) icon.
2.
Tap the Bluetooth tab, and then tap the
(Bluetooth) icon to turn Bluetooth on.
3. Tap Bluetooth > Bluetooth Settings > Services > File Transfer.
4. Under Service Settings, select your preferred settings.
5. Tap Advanced….
6.
Tap the
(Folder) icon and locate the required file folder.
7. Tap ok.
26 Chapter 6 Connections
To Next Page
Loading...
