5. If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a. Remove the Mylar screw covers (1) and the two Phillips PM2.5×6.0 screws (2) that secure
the display bezel to the display assembly.
b. Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom
edge (3) of the display bezel until the bezel disengages from the display enclosure.
c. Remove the display bezel (4). The display bezel is available using spare part number
639440-001.
6. If it is necessary to replace the webcam/microphone module:
a. Detach and release the webcam/microphone module (1) as far as the webcam/microphone
module cable allows. (The webcam/microphone module is attached to the display
enclosure with double-sided tape.)
90 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
