4. Remove the battery (see Battery on page 40).
5. Remove the following components:
a. Hard drive (see
Hard drive on page 43)
b. Optical drive (see
Optical drive on page 41)
c. Keyboard (see
Keyboard on page 52)
d. Keyboard cover (see
Keyboard cover on page 54)
e. Display assembly (see
Display assembly on page 57)
f. Top cover (see
Top cover on page 64)
g. Speakers (see
Speakers on page 72)
h. System board (see
System board on page 74)
Remove the RJ-11 connector cable:
1. Remove the RJ-11 connector from the clip (1) built into the base enclosure.
2. Remove the RJ-11 connector cable (2) from the clips and routing channels built into the base
enclosure.
Reverse this procedure to install the RJ-11 connector cable.
78 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
Need help?
General