HP Invent LP2065

User Guide 3–1
3
Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the
monitor, computer system, and other attached devices, then
follow the instructions below.
✎
Be sure the master power switch, located on the rear panel of the
monitor, is in the off position. The master power switch turns off
all power to the monitor.
Installing the Monitor Pedestal
✎
Do not install the pedestal if the monitor will be used on a wall,
swing arm, or other mounting fixture; instead see the section on
“Mounting the Monitor” in this chapter.
1. Using both hands, position the monitor over the pedestal
base.
Ä
CAUTION: Do not touch the surface of the LCD panel. Pressure on
the panel may cause non-uniformity of color or disorientation of the
liquid crystals. If this occurs the screen will not recover to its normal
condition.