3. Tap View WLAN Networks to choose an available network.
4. In Configure Wireless Networks, select the network to configure.
5. To use authentication, tap the Network Key tab and select the authentication method from the
Authentication list.
6. To use data encryption, select an encryption method from the Data Encryption list.
7. To automatically use a network key, tap The key is automatically provided. Otherwise, enter the
network key manually.
Deleting Wireless Network Settings
You can delete network settings you manually entered. However, if a network was automatically
detected, your HP iPAQ may continue to automatically detect the network.
To delete existing or available wireless network settings:
1. Tap Start > Today > iPAQ Wireless.
2. Tap the WLAN icon to turn WLAN on.
3. Tap the WLAN tab > View WLAN Networks > Wireless tab.
4. In the Configure Wireless Networks box, tap and hold the desired network settings.
5. Tap Remove Settings.
Configuring 802.1x Authentication Settings
Before performing these steps, determine if authentication information is needed by contacting your
network administrator.
1. To manually enter information, tap Start > Today > iPAQ Wireless > WLAN tab > View WLAN
Networks > Wireless tab.
2. In Configure Wireless Networks, select the desired network.
3. For increased security, tap 802.1X tab > Use IEEE 802.1x network access control. Then select
the appropriate EAP type.
NOTE The only two EAP types supported are PEAP and Smart Card or Certificate. Additional
EAP types may be obtained from your network administrator or a third party.
WLAN 73
To Next Page
Loading...
