5. Do either of the following:
• Press and hold down the Shift key while you double-click on the
hub in the Device Chain List.
• Highlight the hub in the Device Chain List, then press and hold
down the Shift key while you click on the Access button.
Note If you don’t hold down the Shift key in the preceding step, HP Stack
Manager displays a graphical representation of the hub. To connect to
the router, click on the Router icon button.
6. After a few seconds, HP Stack Manager displays a window showing
the Copyright screen (momentarily) followed by the Main Menu
screen.
If the Copyright and Main Menu screens appear, the router has been
installed properly and has started up properly; proceed with the setup
procedures in chapter 2. If they do not appear, refer to chapter 4,
“Troubleshooting”.
Figure 1-13. Copyright Screen Figure 1-14. Main Menu Screen
Installation
6. Verify That the Router Starts Up Properly.
1-23
To Next Page
Loading...
Need help?
General
