To Next Page

To Previous Page

5-63

Quality of Service: Managing Bandwidth More Effectively

Globally-Configured QoS

Example. This example shows how to prioritize inbound traffic on the

following source-ports:

Enter the following commands to prioritize packets received from the speci-

fied source ports:

Figure 5-28. Configuring and Displaying Source-Port QoS Priorities

If you later decided to remove source-port A1 from QoS prioritization, you

would enter the following command:

Syntax: no interface < port-list > qos

Disables use of the specified source-port(s) for QoS classi-

fier(s) and resets the priority for the specified source-port(s)

to No-override.

Syntax: show qos port-priority

Lists the QoS port-priority classifiers with their priority

data.

Source-Port Priority

A1 - A3 2

A4 3

B1, B4 5

C1-C3 6

HP Switch(config)# interface 1-3 qos priority 6

HP Switch(config)# interface 4-5 qos priority 5

HP Switch(config)# interface 6-7 qos priority 3

Switch(config)# show qos port-priority

Port priorities

Port Apply rule | DSCP Priority Radius Override

---- ----------- + ------ ----------- ---------------

1 Priority | 6 No-override

2 Priority | 6 No-override

3 Priority | 6 No-override

4 Priority | 5 No-override

5 Priority | 5 No-override

6 Priority | 3 No-override

7 Priority | 3 No-override

8 No-override | No-override No-override

9 No-override | No-override No-override

10 No-override | No-override No-override

HP J8693A Advanced Traffic Management Guide

Other manuals for HP J8693A