High Volt Switch/Router to Wall Power Cord
JG723A#B2E
NEMA L6-20P Cord (NA/MEX/JP/TW)
PDU CABLE NA/MEX/TW/JP
JG647A#B2B
C15 PDU Jumper Cord (NA/MEX/TW/JP)
220 NA
JG647A#B2E
NEMA L6-20P Cord
PDU CABLE NA/MEX/TW/JP
JG646A#B2B
C15 PDU Jumper Cord (NA/MEX/TW/JP)
220 NA
JG646A#B2E
NEMA L6-20P Cord
Configuration Rules:
Note 1
The following Transceivers install into this Controller: (Use #0D1 if switch is CTO0
HP X125 1G SFP LC LH40 1310nm Transceiver
JD061A
HP X120 1G SFP LC LH40 1550nm Transceiver
JD062A
HP X125 1G SFP LC LH70 Transceiver
JD063B
HP X120 1G SFP LC SX Transceiver
JD118B
HP X120 1G SFP LC LX Transceiver
JD119B
Note 2
If the Switch Chassis is to be Factory Integrated (CTO), Then the #0D1 is required on the Switch Chassis and
integrated to the JG662A - HP 800 CTO Enablement. (Min 1/Max 1 Switch per SSP)
Note 3
Localization required on orders without #B2B, #B2C, or #B2E options.
Note 4
If #B2E is selected Then replace Localized option with #B2E for power supply and with #B2E for switch . (Offered
only in NA, Mexico,, Taiwan, and Japan)
Note 7
The following Transceivers install into this Switch:
JD092B - HP X130 10G SFP+ LC SR Transceiver
JD093B - HP X130 10G SFP+ LC LRM Transceiver
JD094B - HP X130 10G SFP+ LC LR Transceiver
JG234A - HP X130 10G SFP+ LC ER 40km Transceiver
Note 8
The following Transceivers install into this Switch:
JD102B - HP X115 100M SFP LC FX Transceiver
JD120B - HP X110 100M SFP LC LX Transceiver
JD090A - HP X110 100M SFP LC LH40 Transceiver
JD118B - HP X120 1G SFP LC SX Transceiver
JD119B - HP X120 1G SFP LC LX Transceiver
JD061A - HP X125 1G SFP LC LH40 1310nm XCVR
JD062A - HP X120 1G SFP LC LH40 1550nm XCVR
QuickSpecs
HP 830 Unified Wired-WLAN Switch Series
Configuration
DA - 14560 Worldwide — Version 8 — June 10, 2014
Page 10
To Next Page
Loading...
