To Next Page

To Previous Page

To use the auto-adjustment feature:

1. Allow the monitor to warm up for 20 minutes before adjusting.

2. Press the -/Auto button on the monitor front panel.

●

You can also press the Menu button, then select Image Control from the OSD Main Menu.

Refer to

Adjusting the Monitor Settings on page 25 in this chapter.

●

If the result is not satisfactory, continue with the procedure.

3. Insert the CD in the disc drive. The CD menu is displayed.

4. Select Open Auto-Adjustment Software. The setup test pattern is displayed.

5. Press the -/Auto button on the monitor front panel to produce a stable, centered image.

6. Press the ESC key or any other key on the keyboard to exit the test pattern.

Using the Auto-Adjustment Function 23

Other manuals for HP L1750

Questions and Answers:

Need help?

Do you have a question about the HP L1750 and is the answer not in the manual?

General

3D	No
Aspect ratio	16:9
Display diagonal	17 \
Display resolution	1280 x 1024 pixels
Vertical scan range	50 - 77 Hz
Horizontal scan range	24 - 83 kHz
Viewing angle, vertical	160 °
Contrast ratio (dynamic)	-
Contrast ratio (typical)	800:1
Display brightness (typical)	300 cd/m²
Supported graphics resolutions	1280 x 1024 (SXGA)
On/off switch	Yes
Power consumption (standby)	- W
USB Type-A downstream ports quantity	0
Tilt angle range	-5 - 35 °
Panel mounting interface	- mm
Product color	Silver
Country of origin	China
Cables included	AC
Sustainability certificates	ENERGY STAR