HP L1940T User Manual

Setting Up the Monitor
Ä
CAUTION: Before beginning to disassemble the monitor, be sure
the monitor is turned off and the power and signal cables are both
disconnected.
Lay the front bezel down on a soft area to prevent it from getting
scratched, defaced, or broken
Å
WARNING: Do not remove the base from the monitor while the
monitor is in the upright position. Before removing the monitor from
the base, ensure that the monitor is lying flat, front bezel down, and
that the base is set to the maximum base extension. Attempting to
remove the monitor from the base while upright or in the minimum
base extension may result in injury to the user.
1. Disconnect and remove the signal and power cables from the
back of the monitor.
Ä
CAUTION: Ensure that the bottom of the monitor base is positioned
over a table or desktop before removing the base from the monitor.
3–10 User Guide

HP L1940T Specifications

General

3D	No
Pixel pitch	0.294 x 0.294 mm
Aspect ratio	5:4
Response time	8 ms
Display diagonal	19 \
Display resolution	1280 x 1024 pixels
Vertical scan range	56 - 76 Hz
Horizontal scan range	30 - 83 kHz
Viewing angle, vertical	135 °
Contrast ratio (dynamic)	-
Contrast ratio (typical)	700:1
Display number of colors	16.78 million colors
Viewing angle, horizontal	140 °
Display brightness (typical)	300 cd/m²
Supported graphics resolutions	1280 x 1024 (SXGA)
On/off switch	Yes
USB hub version	2.0
DVI-I ports quantity	0
USB Type-A downstream ports quantity	2
Pivot angle	0 - 90 °
Tilt angle range	-5 - 35 °
Panel mounting interface	100 x 100 mm
AC input voltage	95 - 265 V
AC input frequency	50 - 60 Hz
Power consumption (max)	60 W
Power consumption (average)	33 W
Power consumption (standby)	2 W
Power consumption (typical)	40 W
Operating temperature (T-T)	5 - 35 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	20 - 80 %
Package depth	241 mm
Package width	508 mm
Package height	521 mm
Package weight	10200 g
Sustainability certificates	ENERGY STAR
Certification	CSA, CE, CISPR, FCC, ISO, TCO, VCCI, TUV, MPR-II
Country of origin	China

Weight and Dimensions

Depth (without stand)	273 mm
Width (without stand)	413 mm
Height (without stand)	362 mm
Weight (without stand)	8400 g