HP L1940T User Manual

Operating the Monitor
■ Input Signal Out of Range— Indicates the monitor does not
support the input signal because the resolution and/or refresh
rate are set higher than the monitor supports. Set the
resolution and refresh rate for 1280 x 1024 at 60 Hz. Restart
your computer for the new settings to take effect.
■ Monitor Going to Sleep— Indicates the screen display is
entering a sleep mode.
■ Check Video Cable— Indicates the video cable is not
properly connected to the computer.
■ No Input Signal— Indicates the monitor is entering a
reduced power state but the power saving feature is set to off.
■ Auto Adjustment in Progress— Displays when auto
adjustment feature is active.
■ OSD Lock—The OSD can be enabled or disabled by
pressing and holding the Menu button on the front panel for
10 seconds. If the OSD is locked, the warning message “OSD
Lock” displays for ten seconds.
❏ If the OSD is locked, press and hold the Menu button for
10 seconds to unlock the OSD.
❏ If the OSD is unlocked, press and hold the Menu button
for 10 seconds to lock the OSD.
Sleep Timer Mode
The Sleep Timer mode is an energy-saving feature that enables
you to set a time for the monitor to power on and off at the same
time every day. This also extends the life of the backlight bulbs in
the monitor. The Sleep Timer has five settings:
■ Set Current Time
■ Set Sleep Time
■ Set On Time
User Guide 4–11

HP L1940T Specifications

General

3D	No
Pixel pitch	0.294 x 0.294 mm
Aspect ratio	5:4
Response time	8 ms
Display diagonal	19 \
Display resolution	1280 x 1024 pixels
Vertical scan range	56 - 76 Hz
Horizontal scan range	30 - 83 kHz
Viewing angle, vertical	135 °
Contrast ratio (dynamic)	-
Contrast ratio (typical)	700:1
Display number of colors	16.78 million colors
Viewing angle, horizontal	140 °
Display brightness (typical)	300 cd/m²
Supported graphics resolutions	1280 x 1024 (SXGA)
On/off switch	Yes
USB hub version	2.0
DVI-I ports quantity	0
USB Type-A downstream ports quantity	2
Pivot angle	0 - 90 °
Tilt angle range	-5 - 35 °
Panel mounting interface	100 x 100 mm
AC input voltage	95 - 265 V
AC input frequency	50 - 60 Hz
Power consumption (max)	60 W
Power consumption (average)	33 W
Power consumption (standby)	2 W
Power consumption (typical)	40 W
Operating temperature (T-T)	5 - 35 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	20 - 80 %
Package depth	241 mm
Package width	508 mm
Package height	521 mm
Package weight	10200 g
Sustainability certificates	ENERGY STAR
Certification	CSA, CE, CISPR, FCC, ISO, TCO, VCCI, TUV, MPR-II
Country of origin	China

Weight and Dimensions

Depth (without stand)	273 mm
Width (without stand)	413 mm
Height (without stand)	362 mm
Weight (without stand)	8400 g