HP L1940T User Manual

58 pages

To Next Page

To Previous Page

Agency Regulatory Notices

The power cord set (flexible cord or wall plug) received with the

monitor meets the requirements for use in the country where you

purchased the equipment.

If you need to obtain a power cord for a different country, you

should purchase a power cord that is approved for use in that

country.

The power cord must be rated for the product and for the voltage

and current marked on the product's electrical ratings label. The

voltage and current rating of the cord should be greater than the

voltage and current rating marked on the product. In addition, the

cross-sectional area of the wire must be a minimum of 0.75 mm²

or 18AWG, and the length of the cord must be between 6 feet

(1.8 m) and 12 feet (3.6 m). If you have questions about the type

of power cord to use, contact your HP authorized service

provider.

A power cord should be routed so that it is not likely to be walked

on or pinched by items placed upon it or against it. Particular

attention should be paid to the plug, electrical outlet, and the

point where the cord exits from the product.

Japanese Power Cord Requirements

For use in Japan, use only the power cord received with this

product.

CAUTION: Do not use the power cord received with this product on

any other products.

C–6 User Guide

Other manuals for HP L1940T

Need help?

Do you have a question about the HP L1940T and is the answer not in the manual?

General

3D	No
Pixel pitch	0.294 x 0.294 mm
Aspect ratio	5:4
Response time	8 ms
Display diagonal	19 \
Display resolution	1280 x 1024 pixels
Vertical scan range	56 - 76 Hz
Horizontal scan range	30 - 83 kHz
Viewing angle, vertical	135 °
Contrast ratio (dynamic)	-
Contrast ratio (typical)	700:1
Display number of colors	16.78 million colors
Viewing angle, horizontal	140 °
Display brightness (typical)	300 cd/m²
Supported graphics resolutions	1280 x 1024 (SXGA)
On/off switch	Yes
USB hub version	2.0
DVI-I ports quantity	0
USB Type-A downstream ports quantity	2
Pivot angle	0 - 90 °
Tilt angle range	-5 - 35 °
Panel mounting interface	100 x 100 mm
AC input voltage	95 - 265 V
AC input frequency	50 - 60 Hz
Power consumption (max)	60 W
Power consumption (average)	33 W
Power consumption (standby)	2 W
Power consumption (typical)	40 W
Operating temperature (T-T)	5 - 35 °C
Storage relative humidity (H-H)	5 - 90 %
Operating relative humidity (H-H)	20 - 80 %
Package depth	241 mm
Package width	508 mm
Package height	521 mm
Package weight	10200 g
Sustainability certificates	ENERGY STAR
Certification	CSA, CE, CISPR, FCC, ISO, TCO, VCCI, TUV, MPR-II
Country of origin	China