HP L200x

Questions and Answers:

K
Kristin McclainAug 3, 2025
How to fix no image on HP L200x Monitor?
- B
  bryanbanksAug 3, 2025
  If no image appears on your HP Monitor, ensure the power cord is correctly connected to the power outlet. Also, press the Power button to turn on the monitor. If the monitor is in power saving mode, try moving the mouse or pressing a key on the keyboard. Verify that your PC is turned on. If the signal cable between your PC and the display is not connected, check the signal cable and try again. If the signal from the PC is out of the display's frequency range, consult the 'Specifications' section of the manual to configure your display.
E
Erica JonesAug 9, 2025
How to unlock OSD on HP L200x Monitor?
- R
  Ryan HollandAug 9, 2025
  If you see an "OSD LOCKED" message on your HP Monitor screen, you can unlock the OSD controls by pushing the MENU button for several seconds until the message “OSD UNLOCKED” appears. This allows you to change the control settings.
C
Catherine RileyAug 15, 2025
What to do if HP Monitor screen color is abnormal?
- L
  Lori GonzalezAug 15, 2025
  If the screen color on your HP Monitor is mono or abnormal, or if the screen blinks, check that the signal cable is properly connected and use a screwdriver to tighten it if necessary. Ensure that the video card is correctly inserted in its slot. Also, set the color setting higher than 24 bits (true color) in Control Panel - Settings. If the screen is set to interlace mode, change it to the recommended resolution.
C
Christopher HamiltonAug 22, 2025
Why does my HP L200x say Unrecognized monitor?
- J
  John SmithAug 22, 2025
  If you see an "Unrecognized monitor, Plug&Play (VESA DDC) monitor found" message on your HP Monitor, make sure to check if the video card supports Plug&Play function.
C
Carlos EwingAug 27, 2025
How to correct display image on HP L200x?
- K
  Kimberly AdkinsAug 28, 2025
  If the display image on your HP Monitor is incorrect, press the AUTO button to automatically adjust the image to the ideal setting. Alternatively, go to Control Panel -> Display -> Settings to adjust the display to the recommended resolution, ensuring the color setting is higher than 24 bits (true color).

HP L200x Specifications

General

Screen Size	20 inches
Panel Type	TN
Brightness	250 cd/m²
Response Time	5 ms
Connectivity	VGA, DVI-D
Viewing Angle (Horizontal)	160 degrees
Viewing Angle (Vertical)	160 degrees