EN
Removal and Replacement
: Bottom assemblies
111
ECU pan removal (continued)
Figure 4-50Removing the ECU Pan (Continued on Next Page)
4
Slowly lift the ECU plate away from the printer chassis.
CAUTION
Be very careful not to damage or break the connectors underneath the ECU plate as
you lift it from the printer chassis.
5
Reach between the plate and the chassis and unwind the cables from their cable
guides until there is enough slack in the cables to allow access to the bottom of
the ECU plate.
6
Unwind and disconnect all cables until the ECU board is separated from the
chassis.
Note
The entire ECU Board can be replaced as a single unit (cables do not ship with the
replacement board; if cables are damaged during removal, you will need to purchase
new ones).
To Next Page
Loading...