EN
Product Operation
: Printer key functionality
27
A form feed may occur when the LEDs on the Control Panel are showing a processing
mode. This could occur if the PC sends only part of the page to the printer because
the PC has not completed processing the entire page. When the Go key is pressed
while data is in the printer, a form feed pending will occur. Once the data the printer
has received is completely formatted and no more data is in the I/O, the partial page
will be ejected due to the form feed pending.
Normal printer operation
When power is supplied to the printer, all LEDs go on and then off. The LEDs will
sequence on and off, one after the other, from the first LED (Go key/LED) to the last
LED (Attention LED). If an error is detected or if paper is out, the printer will enter that
error mode.
When data is downloaded to the printer (during Ready mode), the Ready LED will
blink. When the printer stops receiving data, the Ready LED may continue to blink
while the printer formats the data.
If an error occurs, the printer will enter that error mode and display the error on the
Control Panel.
Error priority
The highest priority error will be displayed if multiple errors occur simultaneously. The
priority of errors, from highest priority (most important) to lowest, is:
1
Fatal Errors
2
Door Open/No Toner Cartridge
3
Paper Jam
4
Paper Out
5
Memory Error
While in any of the errors except Fatal Error, a reset may be performed by pressing
and holding the Go key for five or more seconds, or unplug to reset. When the reset
completes it will return to the error condition. If the error was cleared by the reset
(such as a Memory Error), the printer will return to Ready mode.
To Next Page
Loading...