EN
Product Operation
: Scanner control panel
28
Scanner control panel
The scanner Control Panel consists of two keys; a scan key and a copy key. These
keys have no effect on the printer other than contention for resources.
Scan
Pressing the scan key sends a message to the PC that opens the appropriate
software application to start the scan or starts a scan depending on how the PC
software is configured. If the scan is initiated with no paper in the ADF, an error
message will appear on the PC.
Quick copy
Pressing the copy button initiates a scan that is sent directly to the printer without
using the PC software. If there is no paper in the ADF, the scanner will still attempt to
pick up a sheet of paper. The Quick Copy function will work even if the unit is not
attached to a PC.
Note
Scan Abort: Pressing both copy and scan keys within one half second of each other
causes the scanner to abort the current scan. If there is paper in the scanner, the scan
engine will be in a jam mode, and the paper will have to be removed manually. This
decreases the chance of documents being damaged by the scanner.
Scanner key functionality based on printer status
The following table contains scanner and printer modes and the result of pressing the
scan and/or copy keys. The scanner key has no effect on printer functionality other
than some print functionality will be held off due to contention for resources. The only
print key press that will affect a scan job, other than contention for resources, is a
printer Control Panel reset.
Copy
Scan
To Next Page
Loading...