EN
Removal and Replacement
: Internal assemblies
86
Paper exit sensor flag removal
Figure 4-26Paper Exit Sensor Flag
Prior to this step: Remove the output roller and delivery assembly.
Note
Before proceeding, examine the paper exit sensor flag. It is important to note the position
of the spring mechanism on the flag. The spring must be reinstalled to exactly this
position, because installing it incorrectly will cause a control panel error message.
1
Remove the paper exit sensor flag by pressing down on the left side and pulling
up on the right side.
To reinstall
Place the left side of the flag in the correct position first, then slide the right side into
place, making certain the spring is on top of the flag. If the spring exerts no pressure
on the flag, it may require respringing by giving the spring an extra turn before
reinstalling. The flag should fit snugly in place.
To Next Page
Loading...