EN
Removal and Replacement
: Internal assemblies
87
Fusing element removal
Figure 4-27Metal Clips Holding Fusing Element
Prior to this step: Remove scanner, pods, printer door, front cover, memory card (if
applicable), output roller, and delivery assembly.
Note
Pay special attention to the way these metal clips are attached to the printer chassis
before you remove them. This will make reassembly easier.
The Fusing Element is held in place on each end by two metal spring-loaded clips.
Each clip has a small black lever next to it. These levers must be in the "up" position.
1
Push each clip down and back, releasing it from the printer chassis.
To Next Page
Loading...