EN
Removal and Replacement
: Internal assemblies
88
Fusing element reaassembly
Figure 4-28Reassembly of Fusing Element Clips
Note
During reassembly, make sure the metal clips are seated properly.
The front of the metal clip has a small threaded hole. There is a corresponding hole on
the printer chassis.
1. Slide the front of the metal clip underneath the threaded tab on the printer chassis
so that the two holes line up.
2. Push down on the metal clip (you will feel the tension springs pushing against the
clip) until the small metal tab on the back of the clip snaps into place.
To Next Page
Loading...