EN
Removal and Replacement
: Internal assemblies
96
Pressure roller removal
Figure 4-36 Removing the Pressure Roller (continued on next page)
Prior to this step: Remove the scanner, pods, printer door, memory card (if applicable),
paper guide, front cover back cover, output roller, delivery assembly, fuser assembly,
and gear train.
1
Using a flat-head screwdriver, remove the gear from the end of the Pressure
Roller by gently prying the small plastic tab up from the slot in the end of the roller
axles.
2
Slide the gear off the end of the roller.
To Next Page
Loading...