EN
Removal and Replacement
: Internal assemblies
97
Pressure roller removal
Figure 4-37Removing the Pressure Roller
CAUTION
This Pressure Roller is covered with light contact grease. Do not get it on your clothes.
See Chapter 6, “Parts and diagrams,” for information about ordering pressure roller
grease.
Note
The half bushing on the right of the assembly or the full bushing on the left end of the
assembly are not connected to the printer chassis and may come loose during removal.
3
Loosen the two screws in the fusing guide.
4
Lift the right end of the Pressure Roller out of the half bushing and slowly move
the roller to the right, pulling the left end of the roller axle out of the opening on the
left side of the printer.
To Next Page
Loading...