8
ENWW
Optional 500-Sheet Tray 3
1 Pull the tray out of the printer.
2 Locate the orange plastic packaging
piece that is holding down the tray.
Turn it counter-clockwise and lift up
to remove.
3 To adjust for letter-size paper, pull up
on the rear stop, or to adjust for
A4-size paper, push the rear paper
stop down.
4 For letter-size paper, move the side
width guides outward as far as
possible, or for A4-size paper, move
the side width guides inward as far
as possible.
5 Add the media and make sure that
it is flat in the tray. Keep the media
below the hooks on the side and rear
of the tray.
6 Slide the tray back into the printer.
1
2
3
4
5
To Next Page
Loading...
