16
ENWW
3 Follow the instructions on the screen to install the software.
Note Before installation is complete, make sure that there is a check mark next to
“Print a test page” (when the prompt appears).
In Windows 2000, if the “Found New Hardware Wizard” window reappears before
installation is complete, click Cancel.
4 Click Finish.
5 If you are prompted to restart your computer, click Yes. The test page should
print after your computer restarts. If you are not prompted to restart your
computer, a test page should print immediately.
6 If the test page printed correctly, installation is complete. Continue to “Step 8:
Record and Store Important Information” on page 20. (If nothing prints or if the
test page does not print correctly, see “If You Have Problems” on page 21.)
Windows
2000 and
Windows XP
a The “Found New Hardware Wizard” window should appear on the
computer display. Click Next>.
b Select “Search for a suitable driver for my device (recommended)” and then
click Next>.
c Under “Optional search locations:”, click the locations as needed so that
there is a check mark next to “Specify a location:” (and NO check marks
next to “Floppy disk drives” and “CD-ROM drives”). Click Next>.
d Place the HP LaserJet 2200 CD in the CD-ROM drive.
e Under “Copy manufacturer’s files from:”, type
D:\2000_XP
(where
D
is the
letter of your CD-ROM drive) and then click OK.
f The Wizard should display a window indicating that it has found the driver;
click Next>.
Windows
Millennium
a The “Add New Hardware Wizard” window should appear on the
computer display.
b Select “Specify the location of the driver (Advanced)” and then click Next>.
c Select “Search for the best driver for your device. (Recommended)” and
then click the boxes as needed so that there is a check mark next to
“Specify a location:” (and NO check mark next to “Removable Media”).
d Place the HP LaserJet 2200 CD in the CD-ROM drive.
e Under “Specify a location:”, type
D:\98ME_USB
(where
D
is the letter of
your CD-ROM drive). Click Next>.
To Next Page
Loading...
