HP LaserJet 2200 - Page 23

ENWW
Step 7: Install Printer Software
19
English
To Install the Printer Software
Note
The following instructions are for Windows computers only. If you connected a network
cable to your Macintosh, see “Macintosh Installation” on page 17.
1
Place the HP LaserJet 2200 CD in the CD-ROM drive.
2
When the welcome screen appears, follow the directions on the screen.
If the welcome screen does not appear: click Start, click Run, type D:\SETUP
(where D is the letter of your CD-ROM drive), and then click OK.
3
Click the button next to Install Printer and then follow the instructions on the
screen to install the software.
Note
Before installation is complete, make sure that there is a check mark next to
“Print a test page” (when the prompt appears).
In Windows 2000, if the “Found New Hardware Wizard” window reappears before
installation is complete, click Cancel.
4
Click Finish.
5
If the test page printed correctly, installation is complete. Continue to “Step 8:
Record and Store Important Information” on page 20. (If nothing prints or if the
test page does not print correctly, see “If You Have Problems” on page 21.)
Network Printer Management Software
z
For individual network printer management, use the Embedded
Web Server, included in your HP Jetdirect EIO print server card.
z
For network printer management in commercial and enterprise
environments, you may want to install HP Web JetAdmin. This
software is not available on the HP LaserJet 2200 CD, but you
can download HP Web JetAdmin from the web site listed below.
For more information about the HP Jetdirect Embedded Web Server
or HP Web JetAdmin, go to http://www.hp.com/go/webjetadmin, or
see your electronic user guide, located on the HP LaserJet 2200 CD.