66 Chapter 3 Printer Tips and Maintenance
EN
Note For best results, use a transparency during this process. If a
transparency is not available, use copier grade paper and not
bond or rough paper.
Note During the engine cleaning process, the printer pulls the transparency
into the printer and then stops. This is not a jam. The transparency
will be slowly stepped through the printer to complete the engine
cleaning.
To Start Engine Cleaning
1. Make sure the printer is turned on and in the ready state. Load a
transparency in Tray 1.
2. Press and hold the G
O and JOB CANCEL buttons until all lights
flash. This will take about 10 seconds. Release the buttons when
the lights flash.
3. Press the G
O button.
4. Discard the blank page produced from the engine cleaning
process.
To Next Page
Loading...
