126 Removal and replacement ENWW
Tray 1 assembly
1 Remove all of the covers and the control-panel assembly (see pages 113 through 124).
2 Open tray 1.
3 Lift tray 1 slightly to align the notch (callout 1) in the tray 1 cover (callout 2) with the hinge
pins of the tray 1 hinges (callout 3).
4 Push the right tray 1 hinge to the left while pulling the tray 1 cover to the right to carefully
disengage the hinge pin from the tray 1 cover.
CAUTION Do not pull the tray 1 cover to the right by pulling the notched portion of the tray 1 cover. The
notched portion of the cover bends or breaks easily.
5 Disengage the left tray 1 hinge (callout 4) from the tray 1 cover.
6 Close the tray 1 guide (callout 5).
Figure 51. Removing the tray 1 assembly (1 of 4)
2
2
2
2
2
2
1
3
4
5
To Next Page
Loading...