130 Removal and replacement ENWW
Internal assemblies
Tray 1 pickup roller
1 Remove the following covers
• I/O cover (see page 113)
• DIMM cover (page 115)
• rear cover (page 116)
• front cover (page 119)
2 Use a flatblade screwdriver to release the tab on the cam at the right side of the pickup roller.
3 Slide the cam and the white, plastic roller toward the right side of the printer to release the
pickup roller.
Figure 55. Removing the tray 1 pickup roller (1 of 2)
To Next Page
Loading...