148 Removal and replacement ENWW
Drive assembly
1 Remove the following covers and assemblies:
• I/O cover (see page 113)
• DIMM cover (page 115)
• rear cover (page 116)
• front cover (page 119)
• control panel (page 120)
• top cover assembly (page 121)
• formatter (page 147)
2 Unplug two connectors (callout 1).
3 Unplug one flat, flexible cable (callout 2) from the engine controller PCA.
4 Remove one grounding screw (callout 3).
Figure 73. Removing the drive assembly (1 of 3)
2
2
2
1
2
3
To Next Page
Loading...