HP LaserJet 3390 - Page 9

Duplex solenoid
1. Remove the following components.
●
Right cover. See
Right cover on page 114.
●
Left cover. See
Left cover on page 116.
●
Rear cover. See
Rear cover on page 120.
●
Top cover. See
Top cover on page 122.
●
Convenience-stapler power supply (HP LaserJet 3392 only). See
Convenience-stapler power
supply (HP LaserJet 3392 only) on page 132.
●
Convenience-stapler bracket and strap (HP LaserJet 3392 only). See
Convenience-stapler
power supply bracket and strap (HP LaserJet 3392 only) on page 135.
●
Fan. See
Fan on page 148.
●
Duplex-drive gears. See
Duplex-drive gears on page 150.
2. Disconnect one connector (callout 1; J211) at the ECU. Feed the wire-harness out of the all-in-one
and wire-harness guides.
1
Figure 5-51 Remove the duplex solenoid (1 of 2)
ENWW Internal assemblies 151
fineline6