DIMMs
WARNING! The MFP contains components that are sensitive to electrostatic discharge
(ESD). Always perform service work at an ESD-protected workstation. If an ESD-protected
workstation is not available, discharge body static by grasping the MFP chassis before
touching an ESD-sensitive component. Ground the MFP chassis before servicing the MFP.
NOTE If possible, print a menu map and a configuration page. See Information pages. Use
the information on the these pages to restore any user-set MFP configuration options after
you install the replacement DIMMs.
1 Remove the formatter cover, and open the formatter cage door. See Formatter cover and
formatter.
2 Push the DIMM locking arms away from the DIMM to release it. Remove the DIMM
Figure 6-35 Remove the DIMM
170 6 Removal and replacement
To Next Page
Loading...