Flash memory card (firmware)
WARNING! The MFP contains components that are sensitive to electrostatic discharge
(ESD). Always perform service work at an ESD-protected workstation. If an ESD-protected
workstation is not available, discharge body static by grasping the MFP chassis before
touching an ESD-sensitive component. Ground the MFP chassis before servicing the MFP.
1 Remove the formatter cover, and open the formatter-cage door. See Formatter cover and
formatter.
2 Grasp the flash memory card, and then pull it out of the formatter cage.
NOTE When reinstalling the firmware flash memory card, it must be installed in the slot
marked FIRMWARE SLOT.
Figure 6-36 Remove a flash memory card
User-replaceable parts 171
To Next Page
Loading...