Fax accessory
WARNING! The MFP contains components that are sensitive to electrostatic discharge
(ESD). Always perform service work at an ESD-protected workstation. If an ESD-protected
workstation is not available, discharge body static by grasping the MFP chassis before
touching an ESD-sensitive component. Ground the MFP chassis before servicing the MFP.
1 Remove the formatter cover, and open the formatter-cage door. See Formatter cover and
formatter.
2 Grasp the fax-accessory card, and then pull it out of the formatter cage.
Figure 6-37 Remove the fax accessory
172 6 Removal and replacement
To Next Page
Loading...