4 Reinstallation tip: After installing the replacement output-bin-full sensor, verify that it is in the
upright position. This ensures that the sensor is correctly installed and will be correctly positioned
when the output bin is installed. The lever on the control-panel end of the sensor must be
installed between the plastic MFP cover and the output-bin-detection lever. See
Figure 6-167
Incorrect installation of the output-bin-full sensor and Figure 6-168 Correct installation of the
output-bin-full sensor.
Figure 6-167 Incorrect installation of the output-bin-full sensor
Figure 6-168 Correct installation of the output-bin-full sensor
Internal assemblies 253
To Next Page
Loading...