Clearing jams from the output areas
Use this procedure to clear jams that occur in the output bin, the 3-bin mailbox, or the stapler/stacker.
To clear jams from the output areas
1 If you are using the standard output bin, grasp the handle at the bottom of the output-bin
assembly, and pull it out and then up to remove it.
2 If you are using a 3-bin mailbox or a stapler/stacker, remove any media that is stacked, and then
press and hold the release button on the top of the device. Pull the device away from the MFP.
3 If the jammed media is inside the MFP, carefully pull the jammed media out of the MFP.
4 If the jammed media is inside the 3-bin mailbox or the stapler/stacker, carefully pull the jammed
media up and out of the device.
Jams 347
To Next Page
Loading...