PCL or PS font list
Use the font lists to see which fonts are currently installed in the MFP. (The font lists also show which
fonts are resident on a hard disk or flash DIMM.)
The PS font list shows the PS fonts installed, and gives a sample of those fonts. The following
describes the information that can be found on the PCL font list:
■ Font gives the font names and samples.
■ Pitch/Point indicates the pitch and point size of the font.
■ Escape Sequence (a PCL 5e programming command) is used to select the designated font.
(See the legend at the bottom of the font list page.)
■ Font # is the number used to select fonts from the control panel (not the software application).
Do not confuse the font # with the font ID (see the following information). The number indicates
the DIMM slot where the font is stored.
■ Soft: Downloaded fonts that stay resident in the MFP until other fonts are downloaded to
replace them or until the MFP is turned off.
■ Internal: Fonts that permanently reside in the MFP.
■ Font ID is the number you assign to soft fonts when you download them through software.
Tools for troubleshooting 419
To Next Page
Loading...