Removal and Replacement
Cover amd Doors
7.
8.
9.
Turn the printer around so that the back edge hangs slightly
beyond the edge of the table. Open the printer’s rear door.
Pull outward on the two rear cover tabs to release pressure and
lift slightly. Be sure to pull outward enough to clear the ac
power receptacle (Figure 6-9, callout 1).
Reaching through the access hole (Figure 6-9, callout 2), pull
outward to clear the power switch.
10.Turn the m-inter around and mdl outward on the two front
cover tab; to release pressure’ while lifting (Figure 6-9,
callout 3). Once all cover tabs are free and the ac input and
power switch are clear, lift the cover straight up carefully.
Jre 6-!3 Fkwrmving W Cover (Laserdet 4P/4MP)
Tore-install:
Ensure that the power switch is fully seated in its retaining slot.
When lowering the cover over the chassis, be careful not to snag
the parallel port bail lock (left rear), the ac power input (right
rear), or the power switch. Watch positioning of the front cover
tabs and the control panel cable. Re-connect the control panel cable
and replace any SIMM modules that were removed.
6-11
To Next Page
Loading...