Removal and Replacement
LeffSide Assemblies
To re-instalh
1. Maneuver the assembly back in place, rotating some of the
gears slightly to mesh, if necessary.
,0
2. Tighten the screws beginning in the center and working
outward (Figure 6-16).
a
CA!JTION
Do not tighten the upper two Main Motor screws
until the Main Motor and Gear Train are both in
place. Tightening the screws without the Main
. Motor in place can damage the mount.
P
!
Figure 6-16 Screw Tightening Sequence Example (Lase\rJe’i 4Pshown)
●
6-18
To Next Page
Loading...