Removal and Replacement
Left Side Assemblies
Main Motor
a
1.
2.
●
3.
Remove the Printer Cover, and the Formatter Shield and PCA
(Figure 6-17).
Remove the (1) machine screw through the access hole on the
Gear Train Assembly, approximately two (2) inches below the
top of the Main Motor (Figure 6-17, callout 1).
Remove the (2) self-tapping screws at the top of the Main Motor
and pull the Main Mo{& s~raight up and out (Figure 6-17,
callout 2).
6-19
To Next Page
Loading...