Removal and Replacement
Internal
!ksemblies
Power Switch Assembly (LaserJet 4P/4MP only)
The Power Switch assembly is mounted on the right side of the
printer chassis, below the fan.
1. Remove the Printer Cover.
2. Remove the (3) self tapping screws (Figure 6-23, callout 1).
3. Remove the (2) machine screws (Figare 6-23, callout 2), and
pull the Power Switch Assembly outward to unplug from the
DC Controller.
To access the second machine screw, it maybe
necessary to re-seat the power switch fully
downward in its retaining slot (if it was
dislodged during cover removal).
6-25
To Next Page
Loading...