Removal and Replacement
Internal Assemblies
3.
4.
—
Lift the Transfer Roller and Guide slightly and slide toward the
left to remove. Do not lift the roller more than about 1 inch (2.5
cm) before sliding it out of the right bushing.
Pull the Roller shaft out of the clips on the Transfer Roller
Guide to release the Transfer Roller from the Guide.
Note
—
Tore-install:
If replacing just the Transfer Roller Guide, be
careful not to lose the Transfer Roller gear. It is
only held in place by slight pressure and can fall
off the Roller shaft.
Install the right end first. Ensure that the tabs are seated firmly
in place below the plastic guide (Figure 6-25, callout 2), and push
the Transfer Roller into place.
Transfer Roller Bushings
The Transfer Roller Bushings are located under the left and right
ends of the Transfer Roller (refer to Figure 6-25). It is not
necessary to remove the Printer Cover to replace the bushings.
1.
2.
3.
Open the top door and remove the toner carttidge.
Remove the Transfer Roller (Figure 6-25).
Remove the (1) self-tapping screw and lift the bushing straight
out (the same procedure applies for both the left and right
bushings).
6-28
To Next Page
Loading...