Removal and Replacement
Rear Assemblies
a
Rear Assemblies
Fusing Assembly
1. Remove the Printer Cover.
2. Remove the machine screws with star washers (1 on 4LJ4ML, 2
a
on 4P/4MP) (Figure 6-27, callout 1).
3. Remove the (2) self-tapping screws (Figure 6-27, callout 2).
4. Slide the Fusing Assembly straight out from the rear of the unit
(some resistance may be encountered because of the two
connectors to the DC Controller).
)
1
Figure 6-27 Removing the Fusing Assembly (Laser&?t 4P shown)
6-30
To Next Page
Loading...