Removal and Replacement
Rea’Assemblies
Connector Assembly (Fuser Entrance Guide)
1. Remove the connector wires from each end of the Comector
Assembly (Figure 6-33, callout 1).
o
2. Gently squeeze the cable clip tabs using needle nose pliers and
slide the cable clip out of the frame (Figure 6-33, callout 2).
3. Remove the (1) machine screw (Figure 6-33, callout 3).
4. Slide the Connector Assembly toward the cable clip location and
lift out.
17gurr?6-33 Flemovhmj the Fusw Connector Assembly
Tore-install:
Be certain to correctly align the wires that run inside of the
●
Connector Assembly to avoid damage.
6-36
To Next Page
Loading...