1/0 Information
Connecting to LocalTalk Networks
(LaserJet 4ML/ 4MP)
Connecting to the MIDDLE of a LocalTalk
Network
1. Disconnect the printer from its power source. Insert the new
connector box cable into the LocalTalk port of your printer.
2. Insert one end of the new cable into the connector box.
3. Place the other end of the new cable next to a connector box on
the network.
4. Unplug one cable from the connector box on the network.
c1
~
c1
—
.
@
@
FigureEM connectingtothe MIDDLEd a Locawalk Nshw’k(WTwJd)
5. Insert the new cable into the connector box on the network.
6. Insert the cable you removed from the network into the new
connector box. Then, reconnect the printer to its power source.
B-5
To Next Page
Loading...