Operating Requirements
Media
Specifications
Adhesive Label Specifications
Use the following guidelines when selecting labels:
The top sheet (printing surface) must be of copier quality and
provide good toner adhesion.
The carrier sheet (backing sheet) must be compatible with the
temperatures and pressure of the fusing process, and must be
coated for easy release of the top sheet.
The adhesive must be stable at the 392° F (200° C)
temperatures encountered for 0.1 second in the printer’s fusing
process, and must not produce emissions that exceed exposure
levels or threshold limits established by OSHA and other safety
agencies. Adhesives must not come into direct contact with any
part of the printer.
Labels must be arranged on the carrier sheet so that any
exposed spaces run lengthwise down the sheet. Using label
stock with spaces between the horizontal rows of labels can
often result in labels peeling off during printing, causing serious
jamming and possible printer damage.
wide selection of suitable labels is available through
Hewlett-Packard. A list of available sizes is in the H“PLaserJet
Printer Family Paper Specification Guide, HP Part No. 5002-1801.
See Chapter 1 for ordering information, or contact your local
authorized HP dealer.
CAUTION -
Do not attempt to print on label sheets after any
of the labels have been removed from the sheet.
Damage to the printer may result.
2-13
To Next Page
Loading...