Operating Requirements
Media Specifications
Adhesive Must not be on any external surfaces of the label
before, during or after printing. Label construction
and die-cutting must not allow labels to peel off
during transport, printing, or fusing.
Caliper
Must not exceed 0.007 in. (0,1 9 mm)
Curl
In ream: flat within 0,2 in, (5 mm)
Finishing Precision Cut sheet within 0.031 in. (0.79 mm) of nominal
and 0.20° square.
Fusing Compatibility
Packaging
—
All adhesives, carrier sheets, top sheets, and other
materials used in label construction must be
compatible with the heat and pressure of the fusing
iprocess, Materials must not discolor, melt, offset,
or release hazardous emissions when heated to
392° F (20V C) for 0.1 second,
Moisture proof wrap to preserve properties.
The “flat paper path” (manual feed slot and rear
face-up delivery door) is recommended for
printing adhesive labels.
2-14
To Next Page
Loading...